Flat Rate 16
Showing all 8 results
-
CC Sway Bar Mounts RX7 FD3S
RX7-FD3S Sway Bar Mount w/Integrated Pinch Weld Reinforcement
Made in the USA
$299.99 – $324.99 Select options -
CC Smart Coil Ignition Bracket RX7 FD3S
The ONLY IGN-1A Smart Coil mounting system available on the market that allows you to KEEP your cruise control & A/C.
Made in the USA
$259.99 – $579.95 Select options -
CC AST (Air Separator Tank) RX7 FD3S
100% direct bolt-on.
Works w/ the factory metric thread water level sensor, overflow tank, large & the small radiator hoses & factory AST cap.
Made In The USA
$299.99 – $332.98 Select options -
AEM Electronics IGBT Inductive Smart Coils 30-2853
Includes coil, connector, connector pins, pin lock, weather seals, and dielectric grease. For use with AEM Twin Fire or aftermarket ignition modules. Not for use with distributed applications. AEM IGBT smart coils are intended for coil-near-plug use only.
$79.99 Add to cart -
Adaptronic Modular Mazda RX-7 PNP ECU
Adaptronic Modular Rx7 PNP ecu is based upon the M2000, but with an Rx7 specific connector that allows you to plug the unit right into your OEM wiring harness. This unit can be installed in under 20 minutes. This unit has the same inputs and outputs as the M2000, with the following exceptions:
This PNP(plug and play) has a few complementary outputs, so the OMP for example has 4 wires, but 2 of them are always the inverse of the other 2, so you can do it with only using 2 outputs – whereas you’d need 4 outputs on the wire-in models(m2000/m6000).$1,350.00 Add to cart -
Sale!
-
-
Greddy Compression Tube RX7 FD3S
This is the Greddy Elbow (compression tube) leading into the throttle body for the FD3S RX7. This elbow improves the airflow into the throttle body giving less restriction. This elbow unit itself will not mate to the stock intercooler. Additional piping kit is required for stock intercooler usage.
$175.00 Add to cart
